Promodul - P03

Check the condition of the control system
A precise meaning of all LEDs in the control system Promodul-U can be found in the SI08002 Promodul-P03 diganoseadvice_and_ service

If PROG is in "1" the control isnt set automatically to RUN after turning on
With a special operation the contents of a cassette can be copied on FLASH storage of the CPU
Further advices can be taken from SI08002 Promodul-P03 diagnoseadvice and service

Nomally the SPS program can be read back from the P03 control on the programming location MULITPROG. Exception:

If by reading back the SPS program the error report from P03 control comes up "no original program in CPU", then it has following cause:
Over the system features the download of the SPS source file can be deselceted. Then only the objectcode is on the contol. This can not be read back in the programming system.

A further aspect is to consider:
- It is possible that the technologie guard "Black box" can be insert. This function is ued a some of the mechine poducers. Appopiate subpograms can be edited by the machine producers .

XCX system, XCX20 and MicroLine: No bufferbattrie change is necessary.
Because of a special battrie the buffering is secured for 8 months fully charged. The battrie is chargedin a 4 hour operation with supply voltage.
Promodul-U: At 25°C and a uninterupted buffering of 4 control units following times are garanted:
- With a network mechine UNG115 or UNG230 : 1 year , typical life cycle 10 years
- With network mechine: UNG24 : 1/2 year , typical life cycle: 5 Jahre
Promodul-F: At 25°C and a uninterupted buffering one year is garanted. The typical life cycle is 5 years.
Promodul-P03: Life cycle of the battrie: 3 years